See all products from Wenko
Wenko capri vacuum-loc liquid soap dispenser
Availability:
Out Of Stock
About Product
- The stylish Vacuum-Loc® soap dispenser from the series Capri is detachable and made of white Ceramic.
- The attractive soap dispenser is ideally suitable for mounting next to the washbasin and provides a decorative place for liquid soap or wash lotion.
- This makes the practical soap dispenser a convenient helper in the bathroom, guest toilet or kitchen.
- The soap dispenser holder consists of a high-quality, heavy zinc pressure cast, which is chrome-plated and rustproof.
- The soap dish convinces by its versatile mounting options.
- it can either be firmly screwed to the wall (screws and dowels are included) or mounted using the Power-Loc® adhesive mounting system.
Read full description
Description
The third alternative is mounting using the enclosed Vacuum-Loc® system. The innovation in mounting technology is called Vacuum-Loc®! The unique system enables fast, easy and safe attachment of the accessories to all non-air-permeable and slightly uneven surfaces. The new Vacuum-Loc® system consists of a pump and mounting Locs; there is no need for drilling and screwing, and suction pads are also not required. With the Vacuum-Loc® system, you can forget products falling off the wall - it is an innovation on the market.
Mounting of the Vacuum-Loc® system is so easy and is done in only a few steps.
- Step 1: Cleaning the surface The selected surface must first be cleaned with a clean, damp cloth. Here it is important that the subsurface is completely dry and above all free from grease when mounting. Therefore, bathroom or household cleaning agents should not be used for pre-cleaning.
- Step 2: Fixing the vacuum adapter To attach to the desired surface, simply remove the cap on the front and the protective film of the back of the vacuum adapter. The Vacuum-Loc® is firmly fixed in the desired position with the red spot facing upwards.
- Step 3: Generating a vacuum Press the pump against the Loc and pull out the pump piston until a loud plop is heard. Remove the pump from the Loc, attach the pump piston again and repeat the procedure 3 times.
- Step 4: Can be immediately subjected to loads After the fourth time of applying the pump piston, the adapter can be immediately subjected to loads and the desired accessory can be hung on. The Vacuum Locs can be re-positioned at any time and can be removed without leaving any residues.
Product Code: 15568
There are no reviews yet, be the first to share your opinion.